WHAT IS eCONNECT?

You need an eBike from our company, an eConnect retrofit kit and a compatible Y-cable (depending on motor type), the app (Haibike eConnect) and a mobile data contract. In addition, it might be necessary to buy a compatible skidplate with respective predrilled hole.

The registration can be made via the eConnect app. You can download the app in Google Play Store or in the App Store by entering "Haibike eConnect" into the search bar. Please keep your eConnect card ready.

You need the frame number and the drawing number of your eBike and the eConnect card. On this card you will also find your registration code. Note: The frame number and the drawing number can be found on the frame at the end of the down tube or by removing the battery.

The app can be installed on all Android and iOS smartphones. The app is especially optimised for iOS from version 9.3 and for Android from version 5.0. Of course, the app can also be installed on former versions, however, this may have an adverse effect on some functions of the eConnect app.

Yes, for all 2019 eBike models offered with eConnect, the eConnect key will be no longer part of the delivery and is not available in the aftermarket or in retrofit kit. That means you can activate and deactivate the theft protection exclusively via the app.

In order to perform base charge, a total charging time of 25 minutes has to be achieved and since the support battery is charged by switching on the display of your bike, it is important to comply with the guidelines as this differs depending on the motor type. Yamaha motors: switch on the display five to six times Bosch motors: switch on the display three to four times Flyon motors: switch on the display two times. Tip: Put the bike outside and do not move it in order to charge the support battery more quickly and achieve a stable GPS and mobile phone connection.

With date of eBike registration, the contract runs for 24 months. Regarding retrofit kits, the contract is concluded for 36 months with registration. Afterwards you have the possibility to extend the contract.

There are no additional costs ocurring during the contract term, even if you take your eBike into non-approved countries.

No, you don't need a contract with Deutsche Telekom. The system applies to any other mobile contract, as well. However, the eConnect system runs via the mobile network of Deutsche Telekom.

If you have a bike of 2018 or higher, the firmware 1.2.5 and all retrofit kits are the latest version. All former models and retrofit kit do have the firmware 2.2.5.

The following models feature eConnect as standard:

• SDURO Hardseven 10.0
• SDURO Hardnine 10.0
• SDURO Fullseven 10.0
• SDURO Fullnine 10.0
• SDURO Fullseven LT 10.0
• SDURO Trekking 8.0
• XDURO AllMtn 10.0
• XDURO Nduro 9.0
• XDURO FullFatsix 9.0

The following models feature eConnect as standard:

• XDURO Nduro 10.0
• XDURO Nduro 8.0
• XDURO Nduro 6.0
• XDURO Nduro 5.0
• XDURO AllMtn 10.0
• XDURO AllMtn 8.0
• XDURO AllMtn 7.5
• XDURO AllMtn 6.0
• XDURO AllMtn 5.0
• XDURO AllTrail 6.0
• XDURO AllTrail 5.0
• XDURO Adventr 6.0
• XDURO Adventr 5.0
• XDURO FullFatSix 10.0
• SDURO Fullseven 8.0
• SDURO Fullseven LT 8.0
• SDURO Fullnine 8.0
• SDURO Hardseven 9.0
• SDURO Hardnine 9.0

The following models feature eConnect as standard:

• XDURO Nduro 10.0
• XDURO Nduro 8.0
• XDURO Nduro 5.0
• XDURO AllMtn 10.0
• XDURO AllMtn 8.0
• XDURO AllMtn 5.0
• XDURO AllTrail 6.0
• XDURO AllTrail 5.0
• XDURO Adventr 6.0
• XDURO Adventr 5.0
• XDURO FullFatSix 10.0
• SDURO Trekking 8.0

With Yamaha models and with our new Flyon models, the battery status of your eBike and the estimated range with regard to your last selected support mode is displayed in the app. Special highlight is that the drive unit system is updated via eConnect with all Flyon models.

Unfortunately, this is not possible at the moment, however, it will be available with one of the next updates.

Tracking is performed via the mobile network of Deutsche Telekom with a timing of 15 seconds. If you are in a dead spot in this moment, it might be possible that a part of the route was not tracked due to lack of network coverage.

With eConnect 2.0, only the manual route tracking is available, this means that you start and stop the route yourself. In addition, you have the possibility to give a name to your route and store it after finishing.

Yes, you have the possibility to cancel sending of the message by the stop button which is activated via push notification within the waiting time defined by you.

The message is addressed to the emergency contacts that you defined. You can define max. two emergency contacts.

Yes, you can deactivate this feature via app in the emergency settings.

Of course, you have the possibility to control and monitor various eBikes via the app.

Of course, it does, as the OBU is equipped with a separate support battery which works independently of your bike.

If the eBike is not moved, the eConnect system switches into stand-by mode after five minutes. In this mode, the support battery lasts for 6 months. As soon as the eBike is moved, the support battery will be immediately charged automatically.

No, this is not possible as the motion sensor integrated into the OBU reacts extremely sensitively to vibrations.

In the first warning level, a push notification is sent to your smartphone by the system with the text "My haibike was moved". In the second and acute level you receive a push notification when the eBike was removed and you thus have the possibility to determine the location of your bike via live tracking in the app.

The OBU is dust- and waterproof according to so-called IP67 certification. This means that that it can be submerged in clear water up to max. 1m and for max. 30 minutes (Not possible with other liquids, e. g. salt water, soapy water, etc.).

Consider that the contract term does not start all over again, but the term is transmitted to the new owner of the bike. For instance, if you registered on 15th January 2018 and want to sell your bike on 24th November 2018, the new owner can use the eConnect system for free until 14th January 2020. Please also note that the bike has to be deleted from your account which can be easily made in the app.

eConnect can be used in the following countries: Belgium, Bulgaria, Denmark Germany, Estonia, Finland, France, French Guiana, Gibraltar, Greece, Great Britain, Guadeloupe, Ireland, Iceland, Isle of Man, Italy, Channel Islands, Croatia, La Désirade, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Marie Galante, Martinique, Mayotte, Monaco, Northern Ireland, Norway, Austria, Poland, Portugal, Réunion, Réunion & Mayotte, Romania, Saint Barthelémy, Saint Martin (french part), San Marino, Sweden, Slovakia, Slovenia, Spain, Czech Republic, Hungary, Vatican City, Cyprus.

In this case, the OBU has no server connection and thus the functions are not available However, there will be no additional costs.

We are convinced that transparency is the key to a good relationship. Not only the protection of your privacy but also the processing of your personal data is a very important to us. We process personal data collected when using eConnect in accordance with the data protection regulations.